Ceramic Tile and Grout?
Robert Hutchins
>Hello wilbur!
If you are working on grout with ceramic tile, patience is the only solution. If you hurry this job - regardless the tool - you will wind up with chipped tile. DAMHIKT.
I've used a screwdriver with the bit ground to round the corners, a Dremel with various bits, and something called a grout saw (a hand tool). The Dremel worked but raised a lot of dust and would damage the tile if it slipped (remark the warning about patience, above). The grout saw worked well between 2 pieces of tile but not so well between tile and tub.
All of these problems could easily be put down to bad technique - or none at all - on my part. Most likely the tools are blameless.
If you are removing caulking - not grout - try using the same kind of heat gun you would use to remove paint. It should soften right up and come out fairly easily. Don't overheat it to make it too plastic. Experimentation will find the right amount. Use whatever tools you have at hand or care to modify to make groove scrapers and hooks to pull the plasticized caulking out.
Another caution: if you don't do anything to kill the mildew, you will repeat this job sooner than you'd like. DAMHIKTE. My best results came after removing the caulking, spraying down with bleach/water mixture and allowing it to dry to the touch, then wiping out with clean damp cloth (wrapped around small screwdriver). The second time, I repeated the Clorox-spray-allow-to-dry-then-wipe-up routing 3 times.
Then I sold the house and moved. Well, I sold and move; but it was about 8 months later. Don't know if the mildew came back after the last treatment, but it didn't come back in a few weeks like it did before.
Use a good latex caulking with mildewcide made specifically for tub and shower enclosures.
HTH
BobH