Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

OT-- electrical conduit

Posts

OT-- electrical conduit

#1

OT-- electrical conduit

gary s clarke

>I need to bend some 1/2 inch electrical conduit to hang a shower curtain around an area in my shop and would like to know the best way to bend it. Is there a handy tool that I could buy or should I put it in my vice to hold it? thanks.

Re: OT-- electrical conduit

#2

JL

Re: OT-- electrical conduit

JL

>Of course there's a handy tool - a conduit bender. It has a long handle with a rounded arc of metal at the end. Probably back near the electrical tools. Some are provided without handles.

Re: OT-- electrical conduit

#3

JL

Re: OT-- electrical conduit

JL

>Here is a pic (I hope)


img

Re: OT-- electrical conduit

#4

Re: OT-- electrical conduit

gary s clarke

>thanks for the info and great pic, saved my bacon

Re: OT-- electrical conduit

#5

Tool rental shops...

Ray Newman

>usually have these for a far cheaper rental rate than buying one, & even more so if it will be only used once for one or two days.

Re: OT-- electrical conduit

#6

Alum vs cast iron

Mark Goodall - ATL - tooljunkie

>I bought mine, aluminum head and steel tube for about $30. The cast iron head one was about $60. IIRC rental was $8 for 4 hours or $15 for a day.

Of course a precurved conduit bend piece is about $2.

Happy Woodworking!

Re: OT-- electrical conduit

#7

Re: OT-- electrical conduit - Make one???

Stuart Johnson

>What about turning one. I thought I was going to need one but turned out I didn't. Anyway, I was going to try and turn one. It seems like you could turn a round cylinder of the right size and then turn a grove to hold the conduit.

Any thoughts whether or not this would work?

Re: OT-- electrical conduit

#8

I think this WOOD work

Mark Goodall - ATL - tooljunkie

>I think this would work as long as you're bending thinwalled EMT conduit. The bought ones would be asier to use, but if you were only going to bend one or two pieces, I think a turned grooved circle with a catch would probably work.

The key to these things working is cosntanst steady pressure while turning. Too fast or too slow and the tube will kink, enven in the proper grooved tool. But the right amount of pressure and speed keeps the metal streching and compressing to form the arc without kinking the tube.

Happy Woodworking!