Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

polyuethane

Posts

polyuethane

#1

polyuethane

S. Kincade

>have recently completed a project and applied stain. I then applied an initial coat of water soluble polyuethane. The following day my wife decided to "help" and applied the second coat of polyuethane. The problem started when she applied the NON-water soluble variety. Now the stain has actually started to come off. I haven't touched it again while trying to decide the best course of action. I'd like your opinion please.

Re: polyuethane

#2

Divorce...

Clint Searl, at the base of Haycock Mtn

>is the only answer.

Clint

Re: polyuethane

#3

Oil & Water?

Mark Mandell - Gone Round In Jersey

>If I understand you, you stained the piece, then applied waterbase Poly, and THEN put oil poly over that, correct?

Was the stain oil based? Is the pigment being pulled in the water based poly?

It not clear to me exactly what's happening, but from what I can tell you've got a real mess on your hands that I would tend to strip off completely and start over. If you go that route, do not mix finishes. I have noted a tendency of some waterborne finishes to leach color from dye-stained wood. The usual remedy is to seal the stain under a binding coat such as dewaxed shellac.

If you go with a sealer coat under the poly, make sure that your shellac is fresh or freshly mixed, because I've been told by one major waterborne maker that a binding coat with too much "age" will tend to develope shrink cracks under waterborne finishes, and those cracks then translate into the waterborne finish above.

mm

Re: polyuethane

#4

Re: polyuethane

S. Kincade

>I'd like to thank everyone for your advice. It's very much appreciated.