Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

rounding toy edges

Posts

rounding toy edges

#1

rounding toy edges

Orlando Woodworker

>Hi

I am retired and going to start making toy block sets for sick children and/or their sibling who are staying at the "Ronald McDonald House" here in Orlando, Fl. These kids are really sick and their family's get a week or so free lodging while they enjoy the attractions here.

My problem is that there are 12 sides to each block, all of which need to be rounded. Long ago, I read that someone had built a tumbler for small solid toys that rounded all the edges nicely.

Does anyone know how I should go about making a similar tumbler??

Thanks

Richard

Re: rounding toy edges

#2

Re: rounding toy edges

Lee Schierer - McKean, PA

>What I do whan making blocks is to rip strips of wood to the height and width I want and run them through the router with a round over bit before the pieces get crosscut to length. This leaves only the ends to clean up which I can do quickly on a drum sander mounted in my drill press. You just need to remove the sharpeness of the corner on the ends, not completely round it over. Hopefully you are using maple or poplar for your blocks as red oak tends to splinter and since it is an open pore wood can absorb things.

Lee