Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

VicMarc controller question

Posts

VicMarc controller question

#1

VicMarc controller question

Doug Smith

>We have a 1997 VicMarc VL300 24" swing lathe.

It has a 1.5 hp motor and acts about like a 3/4 hp motor. We removed the motor and had it checked at an electric motor shop and it got a good to go. What's next"

Is there a place to have the controller checked and or adjusted?

Suggestions anyone?

Thank You

DougSmith

McMinnville, OR USA

Re: VicMarc controller question

#2

Re: VicMarc controller question

Eddie Pacheco, San Jose, Ca.

>Hey, Doug.

The guys on the "Turning" messageboard may be able to help you. Look on the left of the screen and you'll see "Turning" listed under "Daily Trivia". Also do a search for some info on the type or model number of the motor controller. Sometimes ther are some trim pot. adjustmenets that can be made to make the motor run better, but these are usually done at the factory and each controller is matched to the motor. Good luck.

Re: VicMarc controller question

#3

Re: VicMarc controller question

Doug Smith

>Eddie,

Thank you for the suggestion. I'll try the turning section.

Doug Smith