Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

OT: Gluing Porcelain

Posts

OT: Gluing Porcelain

#1

OT: Gluing Porcelain

David Hammond, in Powder Springs GA

>I've got a busted teapot lid, in some old blue and white porcelain. What can I use to repair it? It's about 2 1/2" in diameter, slightly domed with a knob on top, and it's a clean, straight break - about one third of the lid broke off, on one side of the knob.

I've got West System Epoxy, Poly Glue, CA, etc, but I wasn't sure what would hold up to the heat of a teapot lid...

Thanks,

David

Re: OT: Gluing Porcelain

#2

Re: OT: Gluing Porcelain

Keith Newton

>CA would be my choice, Now the choice of viscosity would depend on the nature of the break. #2 may be the easiest to control, because it is not so runny.

Some parts, you can just forget about clamping, for those it is great to have a glue like this that will set fast enough while you hold the parts in position with your fingers.

Re: OT: Gluing Porcelain

#3

Re: OT: Gluing Porcelain

Mark Kauder, Phenix City, AL

>David,

I have used CA w/o problem on tea cups, etc. I would worry more about the moisture than the heat.

Mark

Re: OT: Gluing Porcelain

#4

Re: OT: Gluing Porcelain

George@Colonel's Workshop-Havertown PA

>Good Morning David,

I concur with CA glue as the choice. Regarding heat, I use it to fix broken pipes where the stem joins the bowl. Its been a permanent fix--for years in a couple cases.

George

Re: OT: Gluing Porcelain

#5

Re: OT: Gluing Porcelain

David Hammond, in Powder Springs GA

>Thanks folks! CA it is then; I just hope I have some medium viscosity, 'cause thin is all I remember seeing in my shop...

Thanks again,

David

Re: OT: Gluing Porcelain

#6

Great fix!

David Hammond, in Powder Springs GA

>Thanks again guys; the CA did the trick no problem - good as new!

David