Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

bowl on barn wood stand

Posts

bowl on barn wood stand

#1

bowl on barn wood stand

Clay Foster

>This is a piece that will be in a solo exhibition show in Santa Fe in April. Thought maybe some one might be interested in how it was assembled.

The panels are attached to the legs with biscuits. The panels were cut on a taper jig on the table saw with the blade tilted to 45 degrees.

The bowl is burnt pecan with old galvanized sheet iron, brass brads, and tile grout. The panels in the stand are old barn wood, old galvanized sheet iron stitched down with an extravagance of brass brads, and tile grout. The legs of the stand are burnt ash with tile grout. 53" high.


img

Re: bowl on barn wood stand

#2

Re: bowl on barn wood stand

Clay Foster

>The panels are attached to the legs with biscuits. Cauls made from plywood with triangular strips glued to the edges were clamped to the panels. This kept the pipe clamps from slipping off and from marring the panels.

I hope this isn't one of those photos where you can't tell what is going on unless you already know what is going on.

Re: bowl on barn wood stand

#3

Re: bowl on barn wood stand

Clay Foster

>It took a lot of clamps to glue it all together.


img

Re: bowl on barn wood stand

#4

Re: bowl on barn wood stand

Keith Newton

>that looks great. I would like to know how you apply / control the tile grout, and at what point does it go on.

How about a tight shot of the turning? Is there some carving going on there?

Keep up the great work. Keith

Re: bowl on barn wood stand

#5

photo

Clay Foster

>I guess it would be easier to see what is going on if I actually post the photo.


img

Re: bowl on barn wood stand

#6

Re: bowl on barn wood stand

Clay Foster

>I don't have a photo of this bowl, but of one very similar. After the bowl is turned, the pattern is carved into it, and in this example brass wire is attached. The whole bowl is then burnt with a propane torch, wire brushed, and sanded. Tile grout is then rubbed into the carving and around the brass wire. After the grout has set, any grout film is removed with vinegar on a paper towel, and a finish of brown Kiwi shoe polish is applied. There is also grout around the brass brads attaching the sheet metal to the table top.


img

Re: bowl on barn wood stand

#7

Re: bowl on barn wood stand

James Dillon in MD

>Clay,

As usual, your turning and stand are really, really nice and so unique. I love the look of your bowl. Thanks for the closeups of the clamping cauls and the bowl; I will keep your clamping method in mind the next time I need to do something like that. Thanks for posting.

Jim

Re: bowl on barn wood stand

#8

Re: bowl on barn wood stand

Johanna

>Very Santa Fe! It seems ancient and warm.

Do you live there or nearby?