Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

What did I do wrong?

Posts

What did I do wrong?

#1

What did I do wrong?

Don Henthorn

>I am building a fairly large set of chimes and for a clapper I am using four CD's epoxied into a disk and putting walnut slabs on both side of the disk. I turned the resulting block into a round disk the size of the CD's and about 3/4" thick. I'll admit that I didn't let the epoxy cure all that long but it appeared to be hard enough that I couldn't dent it with my fingernail. Any way the thing is delaminating. Is there something about CD's that doesn't like epoxy?

Re: What did I do wrong?

#2

Re: What did I do wrong?

Keith Newton

>You guessed it, Epoxy does not stick good to plastic. Even without the wood, if you put some epoxy on a CD and let it cure, you could just flex the disk, and pop it right off.

However if you sanded the face with coarse sandpaper, or sand-blasted it to give it some "tooth" it would hold better. Although there are probably better glues for dissimilar materials to choose from.

Re: What did I do wrong?

#3

Re: What did I do wrong?

John McGaw

>Did you remove the lacquer coating from the top surface of each CD? That might make the adhesion worse than the already bad plastic-to-plastic bond that epoxy sometimes gives. I'd be tempted to simply go to the local plastic shop and ask if they have any 1/4" polycarbonate scrap cheap. Sanding that well before laminating the wood would give you a better shot at success since it would get rid of the problematic plastic-to-plastic joints.

Re: What did I do wrong?

#4

Thanks, Guys. Should have asked first.

Don Henthorn

>

Re: What did I do wrong?

#5

JL

Re: What did I do wrong?

JL

>Out of curiosity, why did you decide to do the clapper that way?? The CDs wouldn't be exposed except fot the edges if I'm reading your post correctly.

Re: What did I do wrong?

#6

Making a good sounding set of chimes

Don Henthorn

>is not the slap it together proposition that I first supposed. the material that strikes the chimes needs to be of certain materials so that the frequencies of the two meeting materials have a resemblance. This isn't rocket science, as like wood the materials used vary greatly within the same unit, but you need to come as close as you can. The plastic core of the striker makes a better sound than just plain wood. The outside wood skins are tapered toward the edges so that the plastic is the material that actually contacts the tubes. Wish I had my shop. I could sure use a drill press and a few tools right now. (G)

Re: What did I do wrong?

#7

JL

Re: Thanks for the explanation

JL

>