Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

What kind of joiner does David Marks use?

Posts

What kind of joiner does David Marks use?

#1

What kind of joiner does David Marks use?

Terry Alexander

>I just had to post this question. I was watching him last night and he has always used this humongous joiner. In last night's episode, he stays: "Now let's take this over to the 6" joiner"....

So....what kind is his big one and (just curious), how much did/does it cost?

Wonder if he has an 8" joiner also ;-)

Thanks in advance.

Terry Alexander

Re: What kind of joiner does David Marks use?

#2

He says it's an Oliver 

Scott Stafford

>

Re: What kind of joiner does David Marks use?

#3

Re: What kind of joiner does David Marks use?

John Cole

>His 6 inch is an old Jet. In his classroom (this was built onto his workshop after the series ended) he has at least two Delta 8 inch jointers.

Re: What kind of joiner does David Marks use?

#4

Re: What kind of joiner does David Marks use?

Tom Stockton

>When I apprenticed in his shop he had a big old 16" that he had shipped from NJ. Not sure of the brand but definatly old arn.

Tom

Re: What kind of joiner does David Marks use?

#5

Re: What kind of joiner does David Marks use?

Mike Fitterling

>To answer your question "How much?"; I could not find a retail rpice on a new Oliver 16" jointer, but a Northfield 12" I know runs about $11,000 new to start. Northfield are a bit more expensive than Olivers I think, unless you are very, very lucky (heehee, stealth gloat--Mine, $500). :)

Re: What kind of joiner does David Marks use?

#6

Re: David's is rebuilt old arn...

Glenn Madsen near San Francisco

>