Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Staircase trim

Posts

Staircase trim

#1

Staircase trim

Jay

>Hello All...

question about angles and molding..OK have a stairwell with a knee wall on the second set up(6 steps,Landing,6 Steps).Put a pine top on the knee wall with an overhang of about 1 1/4" so was going to trim underneath the pine top with colonial casing the top of molding i cut at a 40deg angle fit nice.when i got to the bottom i couldnt figure out for the life of me how to compound it to wrap corner(thickness of wall and mold back side of wall/pine top.the casing is fat end up to the pine top and the bottom of the pine top overhangs +/- 1 1/4" as well.I'm a decent wood guy but suck at algrebra any ideas.

Re: Staircase trim

#2

Ellis Walentine

The angle is the problem

Ellis Walentine

>This isn't like a crown molding situation where all the pieces are referencing a single plane (the ceiling or soffit). The fact that the side casings are tilted up at 35 or 40� means that, if you want them to meet the bottom piece with clean miters, it won't happen. The drop cut on your side pieces will be 50-55� off vertical, therefore longer by a factor of the tangent of the rake angle. The only way you can make it look perfect would be to make a custom molding for the bottom that is taller than the side moldings, with all the proportions stretched to meet the miters on the side casings. You could make it from a short piece of pine, using whatever tools or cutters you have available, even planes and chisels. The alternative is to cut off the tips of the side miters level with the bottom casing piece and schmooze the profiles together somehow with chisels, rasps, files, etc., until the joints look acceptable to you.

Ellis Walentine, Host

Re: Staircase trim

#3

Re: Staircase trim

Ted Wong

>As Ellis mentioned you'll always get that funky condition at the bottom of the stairs where skirt meets base. Many times there is little or no profile to the trim. Less than a quarter round at the top is pretty easy to fake. And "Shmoozing" the profile is another way I've done it with more complex profiles and have been satisfied.

In some instances I've done plinth blocks at the corner and avoided any problems altogether.

Re: Staircase trim

#4

Re: The angle is the problem

Jay

>thanks so much!!!! i dont feel like such a dummy now!! haha

Re: Staircase trim

#5

Re: Staircase trim

wess23

>I'm not sure exactly what you are up against, but here is how I turn the corner around a stair stringer. (Assuming the pic works.)


img