Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Filling small gaps

Posts

Filling small gaps

#1

Filling small gaps

Ken Krawford

>I am completing some built in bookcases. They have face frames with the carcass of plywood. At the edges where face frame joins the plywood, there are very tiny voids (less than .5 mm). Much too small for wood filler.

Any suggestions on what to fill with, bearing in mind that these are vertical surfaces.

Re: Filling small gaps

#2

JL

Re: Filling small gaps

JL

>What finish are you planning on using? What wood also?

Re: Filling small gaps

#3

Ellis Walentine

Re: Filling small gaps

Ellis Walentine

>Hi Ken,

I'm not sure why you feel these gaps are too small for wood filler. With a putty knife you can fill just about any surface imperfection.

Ellis Walentine

Re: Filling small gaps

#4

Re: Filling small gaps

mike mcnerney

>depending how how many lineal feet I had and how noticeable. I have used thick crazy glue, put a bead on & push it in with you finder with or without a disposable glove, then spray on the accelarator.

scrape &/or sand to clean up.

5 min epxy is thicker therfor better but messier & mor clean up & sometimes you have to wait a half hour before cleanup.

water base pore filler or even water base urethane is my 3rd choice a 2hre wait to clean up.

Or try thinning whatever kind of plastic wood you use with the appropriate thiner so you can push it in with a putty knife.

4 of a hundred ways

mike mcnerney in ottawa

Re: Filling small gaps

#5

Re: Filling small gaps

Ken Krawford

>I'm using Famowood filler. The cabinet is birch plywood with poplar face frames. When I sand the filler, all the filler is gone but the crack remains. I'm going to paint the piece when finished.

Re: Filling small gaps

#6

Re: Filling small gaps

pecker

>When I have really tiny gaps to fill, I will use DAP Plastic Wood and force it into the gap with my thumb, rather than using a putty knife, which just smears a layer over the gap. This might be painful if you had to do 8 feet of it, though.

Since you're painting, maybe try something less thick...more like a caulk consistency.