>The best price I have found on a Steel City drum sander is with The Utter Guys, an internet/e-bay seller. They seem to have a wide range of products, and are considerably cheaper than several other sites on every item I have price checked. Their e-bay feedback is 99.something positive, but...
Have any of you dealt with them, or know of someone who has?
>Check out Tool King, also on ebay. They just posted the same sander for $779 but with free shipping. That works out $70 less than Utter Guys.
I was just getting ready to post and ask if anyone has experience with this sander. I was told on another forum by a guy who was looking at the Steel City table saws at a local dealer that the dealer told him there were problems with the Steel City sander. Said he had sold two and both were returned with problems. Didn't elaborate on what the problems were.
With the $100 rebate through the end of March and Tool King's price, it's hard not to at least give it thorough consideration though.
>Well, after having said that about tool king, I can't find it on ebay anymore. When I go to the Tool King web site, they still show the price as 779 but it says out of stock.
>…online and in the store. They are usually quite competetive in their pricing, and they are nice people to deal with. Not as big as International Tool in Davie, but a breath of fresh air up here in the northern part of the state.
I haven't been in the store since they picked up the Steel City line. I'm going to have to get down there. It's on my usual circuit to Woodcraft in Casselberry.
Minimum thickness doesn't mean much. You can easily attach your workpiece to a backer board and sand it to zero thickness, even if the stated minimum thickness is 1".
If minimum thickness is the only difference (your call) go with the lower price.
>I have an older Performax 16/32 that I really like. I doubt the minimum thickness claim. I got it used and the feed belt had wear on it. Slick spots. I did nto have the instructions and tried to adjust the feed belt. It tracked badly and frazzled the edges. (My fault, I screwed it up in a fit of ignorance) Anyway, I replaced the feed blet and found the new one to be a little "Puffy". If you cranked it down real thin, it would sand the high spots off the belt. You can hear it "snicking" the sand paper on th drum against the drive belt. That's when I realized what the shiny spots were on the old belt. So now I use a backer board to keep the sand paper from touching the drive belt around the object being sanded.