Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Spar Varnish Red oak Bubbles

Posts

Spar Varnish Red oak Bubbles

#1

Spar Varnish Red oak Bubbles

Jeffrey D. Rose

>Hi Everybody,

I am appling some spar varnish to red oak that will encase a window. I am using the spar varnish because it will be exposed the a lot of sun light and possible moisture from time to time. I planed the oak, let it sit inside for two weeks and now I am putting the varnish on it. At all the open grain points there are bubbles popping up. What causes this and will it cause problems down the road if I sand these bubbles out and put another coat of spar varnish on?

TIA,

Jeff in Iowa.

Re: Spar Varnish Red oak Bubbles

#2

needs thinning

bill tindal, E.TN

>In response to the insignificant contribution to air quality that coatings contribute, the EPA has made formulators reduce the amount of solvent in varnish and the like. The bubbles are not popping because the varnish is too thick. Thin it about 20% with mineral spirits, or warm it and the problem will go away.

Re: Spar Varnish Red oak Bubbles

#3

Re: Spar Varnish Red oak Bubbles

Tomm

>I have found that when I get small bubbles in a finish it is usually because I finished the piece when the wood was colder that the shop temperature. As the wood reaches the shop temperature, air in the wood expands and it tries to push out through the finish causing small bubbles. When you turn the heat on in the shop the air warms quickly but wood takes longer to reach the the air temperature.

Re: Spar Varnish Red oak Bubbles

#4

Re: Bill's right, but

Glenn Madsen near San Francisco

>it's the red oak causing the problem. It's a loose bunch of straws that holds air, releasing it into the finish, whatever it is.

Bill's right. Thin the spar varnish. But there will still be some bubbles, until the surface is sealed. For interior stuff, I wipe on several thin coats of dewaxed shellac first, if I'm using red oak.

Re: Spar Varnish Red oak Bubbles

#5

I agree and...

Lee Schierer - McKean, PA

>I agree with the cold wood warming up and causing bubbles. The pores in red oak are quite large and open. The wet finish enters the pores and then skins over along with the rest of the surface. As the wood warms up, the air trapped below the finish in the pore warms up and pushes the wet finsih out of the pore forming a bubble. To prevent bubbles, make sure the wood is warm when the finish is applied and keep the wood warm for several days until the trapped finish cures. Bubbles can be sanded out and generally don't appear again.

Lee

Re: Spar Varnish Red oak Bubbles

#6

Re: Bill's right, but

Bill White

>Ahhh. The joys of red oak. I finished a project with Watco, and it took a week for the pores to stop bleeding oil.

Bill