Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Wood Seasonal Expansion question?

Posts

Wood Seasonal Expansion question?

#1

Wood Seasonal Expansion question?

Barry Irby

>I am making a hunt table similar to the one in the Dec. Issue of FWW. The plan calls for the sides and back to be made of two rails and a floating panel in the center. The Panel is actually a board the same thickness as the rails and 7 1/2" wide, but is left free to float, being restrained by short tennons on the ends and splines into the rails. There are decorative beads to somewhat disguise the joints.

My question is, since I am building this in winter, should I install a little space to allow for summer expansion? I'm dealing with very old, but freshly resawn quarter sawn heart pine. How much space would you leave?

Re: Wood Seasonal Expansion question?

#2

Re: Wood Seasonal Expansion question? *LINK*

Ed Mulligan, Cape Cod

>The link below will calculate seasonal wood movement. There's no table entry for SYP so you'll have to use one of the 4 species that comprise SYP: shortleaf, longleaf, loblolly or slash pine.

You'll have to know the moisture content which you can determine with a meter or by the oven-dry method.

Ed


Shrinkulator

Re: Wood Seasonal Expansion question?

#3

Re: Wood Expandometer on the cheap

Dave Mount, -27 F this morning

>Barry--

This is too late to help you, but it reminds me of a tip I saw somewhere about making a shop gauge to assess humidity/expansion/contraction in the shop. Next time you glue up a wide panel (the wider the better, 24" or more), save a trimming off the end (just an inch wide is fine). Measure it's length (width in it's original orientation) and record it along with the time of year and any other info relevant to the current conditions. Then, over time, measure it at other times, making the same notations. Over time, this provides a point of reference to the effect of recent shop conditions on wood moisture content. It's not an absolute measurement, but gives relative information. When you're facing a decision like your current one, measure your index stick and consider it in the context of the overall variation you've seen.

Of course, this assumes that the wood you are using is well acclimated to the same conditions that your index stick is. Also, the index stick, being narrow and with massive endgrain exposure, will respond to changes in humidity somewhat faster than lumber will. I suppose you could slow this down a little by putting a very light coat of finish on your index stick.

I had one of these for a time, and it was interesting to watch. Eventually I broke down and bought a hygrometer for the shop. I have a moisture meter too, but the hygrometer tells me most of what I need to know. The shop humidity flucuates seasonally, but is pretty stable day to day.

Best,

Dave, -27 F this morning, -49 wind chill

Re: Wood Seasonal Expansion question?

#4

Try my Wood Movement Calculator *LINK*

Larry Marker in Alabama

>My free wood movement calculator covers SYP. You can get it right here on the Badger Pond Downloads page in the Archives. Use this link and go to the very bottom of the page and click on the link there. I wrote this program a few years ago for my own use and decided to make it available to the public for free.

Let me know if you have any questions or any problems with it.

Larry


Badger Pond Downloads Page