Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Center point when using a faceplate

Posts

Center point when using a faceplate

#1

Center point when using a faceplate

john Lucas

I was answering a question that involved centering a bowl after using a faceplate. I start my bowls between centers so there is always a center mark left from the tailstock. Years ago I used mostly faceplates and occasionally needed to have a center mark. I built this device. It fits in the threaded side of the faceplate and has a center pin that slide through it. Just drop this in the faceplate, drop the pin in and tap it with a mallet. Now you have a center mark. Very handy when you reverse turn a bowl. I simply put a piece of leather over the chuck, bring up the tailstock and put it in this center mark and now my bowl is centered so I can turn the foot.

Re: Center point when using a faceplate

#2

Re: Center point when using a faceplate

Jim Seyfried

I have one similar to yours that I bought from Carter Products.

http://www.carterproducts.com/band-saw-products/accuright/1-x-8-accurightr-center-mastertm-blank-creation-system