Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Ever run into machine setting epoxy grout? *LINK*

Posts

Ever run into machine setting epoxy grout? *LINK*

#1

Ever run into machine setting epoxy grout? *LINK*

Dick Coers

My copy lathe arrived today. It took 2 forklifts to get the 10' long skids out of the truck. I could see some concrete under the pedestals, kind of surprising. I was just going to leave it there and use the leveling bolts, but just couldn't let it look that way. Tried using a Bosch demo hammer to knock it out, but that just chipped the edges. We then sent a demo bar into some holes in the pedestals and hit that with a sledge. You would not believe the number and intensity of the blows needed to knock it out. I was starting to get concerned about the cast iron! Finally got it all chipped out, but it was crazy hard work. I had to do some Google work to figure out what the heck it was. This stuff has 16,800 psi compressive strength. Makes concrete look like a wimp! Looks like a pretty sweet way to place a machine though. Keep it off the floor, nice and level. Build a little dam around the pedestals with some space around that and the pedestal, then pour in the grout. Pictures of the lathe coming soon, it's one heck of a cast iron beast!


http://www.micorco.com/epoxy-grout/

Re: Ever run into machine setting epoxy grout? *LINK*

#2

Re: Ever run into machine setting epoxy grout?

Keith Newton

Dick, I've mixed up topping mix with epoxy rather than water, and gotten something probably similar.

One place I did that was to make a threshold for the double doors where I roll one of those steel wheel industrial carts in with about 20 sheets of 3/4"plywood or MDF on it. It has held up for about 30 years.

Congrats on getting the lathe in. And glad you didn't break a flange casting trying to open those bolt holes.

Re: Ever run into machine setting epoxy grout? *LINK*

#3

Re: Ever run into machine setting epoxy grout?

Dale Miner

I used to work in an integrated steel mill. The equipment ranged from small to monster. Epoxy and other type setting grouts were common. The epoxy was the toughest and also virtually impervious to oil.