Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Vicmarc 3-step jaws

Posts

Vicmarc 3-step jaws

#1

Vicmarc 3-step jaws

Ted Evans

Do any of you use the Vicmarc 3-step dovetail jaws, and if so, what are the pros and cons compared to the standard dovetail jaws that come with the vm100 chuck? Thanks for your input and suggestions.

Re: Vicmarc 3-step jaws

#2

Re: Vicmarc 3-step jaws

John Lucas

If your talking about the flat dovetail jaws that fit 3 different sizes, then I have one, don't use it. It looked like a good idea at the time. I though it would fill some holes in my arsenal of jaws but apparently those holes don't exist because I've never even mounted it.

Re: Vicmarc 3-step jaws

#3

Re: Vicmarc 3-step jaws

Alan Van art

I have the Nova equivalent to what you refer. If you are turning very narrow forms, like vases, or your bowls have long tenons, or I suppose it could be used on some spindle turnings. Mostly, however, I find that when you are trying to use the inner jaws, the outer jaws get in the way.

Re: Vicmarc 3-step jaws

#4

Re: Vicmarc 3-step jaws

Jorge Casta�eda

Ted,

I have that set and did came handy when making stair parts. I think its for spindle work exclusively and there are some issues at the end of the spindle when using the 2 smaller ones if you are making a cylinder, no big deal, just flip it end for end and clean up. No problem with squared ends.

Re: Vicmarc 3-step jaws

#5

Re: Vicmarc 3-step jaws

Ted Evans

Thanks for the info John and Alan, it was what I was looking for. So I ordered the VM100 with standard jaws. I have been using a Talon but after getting a VM120 last week, it became necessary to also get the 100. I use the Talon with the step jaws for smaller projects. Thanks again.

Re: Vicmarc 3-step jaws

#6

Re: Vicmarc 3-step jaws

Ted Evans

Thanks for the info Jorge, I believe the standard jaws will work better for me.