Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Carving a dragonfly on this turning.

Posts

Carving a dragonfly on this turning.

#1

Carving a dragonfly on this turning.

Keith Newton----Little Rock, Arkansas

I am working on a cherry turning that I am just starting into the carving of its eyes. In the real world, the facets are hexagonal like honeycomb. Of course, laying them out is challenging, then carving them domed is even a greater task.

Have any of you got suggestions for this? I would like for the facets to be ~3/8".

Re: Carving a dragonfly on this turning.

#2

Too late to help,

Keith Newton----Little Rock, Arkansas

I should have tried working this out on a sample instead of the actual piece, but I sometimes, I have at times managed to stumble in the right direction. I'm not sure this is one of those times, but I am half way through the eye part. I hope going back the other way, that I can keep the strokes consistent on the next 5000 strokes.

The facets here look more like snake skin than honeycomb / eyes, but I had been thinking of following this with a snake theme, and it's nice to have this part worked out before the rest of that design is even started.

A few months ago, I captured my favorite Nature image of the Summer. I had the good fortune to photograph four Diamondback water-snakes mating. I am trying to tie my photos into my woodwork, so,,,,,,,,, need I say, there is a snake vessel about to slither over my horizon.

I guess I may need to call this one the Snake-eyed Dragon.