Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

My new vacuum chuck for *LINK*

Posts

My new vacuum chuck for *LINK*

#1

My new vacuum chuck for *LINK*

Rich Pearson in Mill creek, WA

my Jet 1236 Lathe. Fellow 1236 owners know that the hand wheels that exist have small male left hand threaded "stud" to attach it to the spindle. This creates a problem for mounting and dismounting a home-made vacuum chuck. Properly drilling out the small stud and still allowing for a draw bar or knock out bar is a very daunting task (for Beal or Don Pencil buffers) to secure a MT2 fixture.

I had been impressed with JT Turning Tools approach to hand wheels and vacuum adapters and contacted them to see about a custom hand wheel for my 1236. Tom Steyer was a pure joy to work with. He made a hand wheel for me which also accepts the JT Vacuum Adapter. The finish, fit and precision are great! The vacuum adapter runs smoothly without any drag.

I use a 10-20 piece of all-thread for both functions although the through hole is large enough to use a 3/16" drill rod for a knock out as well.

I have modified my 1236 to use a DC variable speed motor, however Tom engineered (and tested) the hand wheel to fit a stock 1236. Since it is now engineered, Jet 1236 hand wheels are available even if they do not show on the website yet.

The set-up looks great, functions great and Tom was easy to work with.

JT Turning tools delivers!

Thank you Tom!

top: photo of hand wheel and vacuum adapter in place:


Bottom: Vacuum hub with standard 2" x 4" plumbing fitting (foam seal yet to be added )




JT Turning Tools

Re: My new vacuum chuck for *LINK*

#2

Ellis Walentine

Nice job

Ellis Walentine

How will you handle the foam seal?

Cheers,

Ellis Walentine

Re: My new vacuum chuck for *LINK*

#3

The foam seal will be

Rich Pearson in Mill creek, WA

installed as per the suggestions in the installation page.

:� Install gasket material on the vacuum cups.

o Closed-cell foam materials make the best gaskets for vacuum cups. They are

inexpensive, and readily obtainable from craft supply stores or craft departments in

department stores. Known by various names such as Craft Foam, Play Foam, Funky

Foam and the like, the foam is available in sheets of various colors. We recommend

3mm (1/8�) foam, white in color. This thickness provides a good cushion and is easy to

work, although other thicknesses, (2mm or 4mm) will work too. The white color is

preferred because there is minimum chance of a color mark being transferred to your

project during vacuum chucking. The foam is usually available in plain back or selfadhesive

backed. Either will work, but I think the self-adhesive is easier to use, because

you don�t have to apply any glue. Cut a disc at least 1�-1.5� larger than the diameter of

the cup, peel off the backer, and apply directly to the face rim of the cup. Work the

material over the outside of the rim and press down on the outside of the cup. Apply a

wrap of masking tape or electrical tape across the joint between the foam and the cup �

this foam has a �memory� and will try to straighten out if it can. You can cut out the

center of the disk if you want to, but all you really need is a �� hole in the middle to

allow the vacuum to work. You will find this material to be surprisingly durable, but

you will have to replace it occasionally when worn out or damaged.