Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Scrapers need a burr?!

Posts

Scrapers need a burr?!

#1

karl jr

Scrapers need a burr?!

karl jr

I did a few more little HF's, freehand this time (as opposed to captured). Raise a burr, and what do you know, it works!

This tells me two things. The set-up of the captured system was incorrect (why use a captured rig when hollowing 5 inches, a person might ask?) and I need to pay more attention to the cutting edge ane tool presentation.

Wetting the outside help prevent checking, also, like the good turners say.

KTK

Re: Scrapers need a burr?!

#2

Lyle Jamieson

Re: Scrapers need a burr?!

Lyle Jamieson

�why use a captured rig when hollowing 5 inches, a person might ask�

Because it is easier, faster, safer, more fun, never get a catch, never cut through the side wall, not working blind with the laser, no fear, you can eat a sandwich and hollow at the same time. (At least my wife could, Im not good at multi-tasking)

I use the captured system for small things like Christmas orniments and lidded boxes because of the fingertip control. You are correct to think your captured system is set up incorrectly. When set up correctly a 10 year old kid can do it. Look at the installation instruction sheet on my web site, www.lylejamieson.com. It is at the top of the tool menu section. This set up will be necessary for any supported/captured system.

Re: Scrapers need a burr?!

#3

karl jr

Re: Scrapers need a burr?!

karl jr

Thanks Lyle. I'll check it out.

Re: Scrapers need a burr?!

#4

Re: Scrapers need a burr?!

robo hippy

If I am roughing out hollow forms, I will usually do that free hand, but with a laser pointer (the handle and laser from my McNaughton coring tool). For finishing them, I prefer a captured system. Just a lot more stable, and easier to get good finish cuts.

robo hippy