Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

I may be the only one with this problem

Posts

I may be the only one with this problem

#1

Steven Antonucci

I may be the only one with this problem

steven antonucci

or I may not be. So I figured I would ask!

When I get a piece of buggy wood, I remove all of the frass in the holes with a combination of picks that I have made from sewing needles and compreseed air. It takes a long time, but in the end I much prefer the look andknowing that all of the former tenants have been evicted.

Now, my issue is that I am completely diligent about ALL of the the frass. Every hole, every micro dot. I have a piece of maple that has some small beetles in it, and while I am 99% sure that the bugs are all gone, some of the holes still have some 'bug doo' in them.

Does anyone have a better way of loosening this stuff? I ran the compressor up over 100 PSI, and I still couldn't blow it out. Most of the holes at this point at 1/32" or less and my pins just pack the stuff in...

Steve

Re: I may be the only one with this problem

#2

Re: I may be the only one with this problem

Stuart Johnson

Steve, you're need to turn some fresh Texas Mesquite. The bugs splat and don't leave any little 1/32 inch holes. A number 9 crochet hook is about the right size. In your case what about getting an old dentist drill?

Re: I may be the only one with this problem

#3

Re: I may be the only one with this problem

Terry Scott

Steve If I get a nice piece of wood like that I just carve bug holes all over it with the dremel Plunge with a round bit then drag it out of the hole . If there are any stowaways they get a hair cut

All the branch on this work was done this way


Re: I may be the only one with this problem

#4

Re: I may be the only one with this problem

Dale Miner

I've had a couple of pieces of wood that had the small holes (powder post beetles?) and I used a small drill bit held in a pin chuck. I don't remember the # of the drill bit, but would guess it to be about .025" diameter. Slow going, but having all the holes cleaned out does make the prior bug work more appealing.

Later,

Dale M

Re: I may be the only one with this problem

#5

Re: I may be the only one with this problem

Barry Irby

You might try this on a scrap, but try wetting it to see if the grass will swell and fall out. I have misted pieces with a spray bottle and sometimes it works and sometimes not.

Re: I may be the only one with this problem

#6

Re: I may be the only one with this problem

John Veerkamp

Steve,

I got several sizes of worn dental pics from my dentist. Some are hooked, some are straight. I've been able to clean out almost every sized hole this way. Any I can't drag out I poke the pic as far as possible figuring that a skewered worm is a dead worm. never had a problem, even with ambrosia maple.

John

Re: I may be the only one with this problem

#7

i have boiled afew with zillion holes

bob davis

then they can be blown out