Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Like Macrame - With Spaghetti *LINK*

Posts

Like Macrame - With Spaghetti *LINK*

#1

Like Macrame - With Spaghetti *LINK*

charlie belden

Well, the first Arduino stamp controlled piece is wired up and working. But even though there are only six wires to deal with - it was like trying to do macrame - with spaghetti - threading them passed each other INSIDE the piece - getting them out through a 7/8" hole in the bottom of the piece - and then plugged into six different locations on the Arduino. But it WORKS - the top of the finial glowing and flickering a wierd blue, a shadow passing over a little sensor on the piece produces a changing tone - that's not unpleasant to hear.

This is the first part of a three part piece that will be called Three Sisters inspired by - three of my pseudo adoptees - who happen to in fact be sisters - actually a half sister and two full sisters. The oldest is a night person who aspires to living in a damp castle in Scotland. Her part is a vase type piece - with cracks and splits and checks - through which a flickering candle will shine (she should've been born prior to electrification). This piece represents the youngest of the three - an outgoing energetic kid who's a laughing chatter box one minute and a silent, uncommunicative kid the next. The third piece in this set will be similar to this form, but will use RGB LEDs whose color can be run the spectrum - constantly changing and unpredicatble.

This Modular Approach to using the Arduino should provide a lot of flexibility for using the Arduino. Perhaps, by providing a few examples, along with the illustrations and "sketches"/programs, others will play with this method of doing dynamic pieces. Will post details of this piece in my next post.

As always, questions, comments, suggestions, constructive criticism welcomed


Vid of 1st Component of Three Sisters

Re: Like Macrame - With Spaghetti *LINK*

#3

Neat!

Tony - Memphis

I've been using my Arduino to communitcate to a couple of Dallas temp sensors to I could store two temps for comparison. I'm using an sd card shield with an RTC. Neat stuff. I was playing with a hall effect sensor last week. I was planing on hooking it up to my drill press to measure RPM for kicks.

Tony