Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

I stand corrected

Posts

I stand corrected

#1

I stand corrected

Cyril Griesbach

I have posted my concerns regarding the AAW Board of Directors powers to amend the By-Laws without membership approval. I believe that in that post I mentioned that I had made only a quick reading of the By-Laws but that is not a valid excuse.

I have looked at that wording again and I retract my concerns as it reads as follows:

(Section 14.01 Amendments. These Bylaws may be altered or

Amended by a majority vote of the Board of Directors. However, if

a majority of the Board determines that addition, revision or repeal

of a fundamental principle of these Bylaws is required, then that

act must be confirmed by a majority of the members of the

Association then casting ballots.

I am willing the trust the Board to make minor revisions and have the integrity to faithfully determine if any changes are a "fundamental principle of these Bylaws" and bring it to a confirmation of the membership.

I apologize for my hasty comments and stand corrected.

Re: I stand corrected

#2

Re:You have overcorrected Cyril, ....

JamieDonaldson

... because a change to the ByLaws by membership can only go forward if approved by a majority of the BOD. What if a BOD is corrupt or votes as a block, ending any possible change proposed by the members? >(

Re: I stand corrected

#3

Re:You have overcorrected Cyril, ....

Cyril Griesbach

Jamie, you are correct. I corrected my original statement but I'm not saying that such changes are unnecessary. I still believe they are necessary.

Cyril