Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

How do I Glue Magnets?

Posts

How do I Glue Magnets?

#1

How do I Glue Magnets?

Doug Wolf

I bought some rare earth magnets to hold a lid on a box. I drilled 1/4" holes in the rim of the lid and the box and now I can't find any type of glue that will hold them in the holes. They seem fine until I pull the lid off 5 or 6 times, then they pull out of the holes.

I tried "E-6000" (like a silicone glue), 5 minute epoxy, Thin CA glue.

If anybody has had better luck, I would like to know what to use.

Thanks in advance.

Re: How do I Glue Magnets?

#2

Re: How do I Glue Magnets?

Barbara Gill

What about gluing plugs in each hole to trap the magnets? Hopefully the glue will hold the wood.

Re: How do I Glue Magnets?

#3

Re: How do I Glue Magnets?

Bill Youngblood

Doug - several years ago I used either medium or thick CA glue to hold magnets for doors on a cabinet. They are still holding. Might be worth a try. Good luck.

Re: How do I Glue Magnets?

#4

Re: How do I Glue Magnets?

Dave Belser

Rough up the nickle surface slightly with fine grit sandpaper (400 or so) and use super glue. I've had good success with this technique. Other tips - use tighter fit on the holes. I sometimes use thin glue in the hole first and let it dry. The magnets can be handled with tape or another magnet and a piece of plastic between to prevent the second magnet from being glued on also.

Hope that helps.

- Dave

Re: How do I Glue Magnets?

#5

Re: How do I Glue Magnets?

john lucas

I watched Sharon Daughty do her boxes. She used 1/8" magnets, counter sunk them below the surface and filled in the gap with sawdust. She used CA glue. I think it was thin but her magnets fit really snug. She also used the CA to set the sawdust.

Re: How do I Glue Magnets?

#6

Re: How do I Glue Magnets?

john lopez

shoe goop