Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Xmas Ornament Project question

Posts

Xmas Ornament Project question

#1

Xmas Ornament Project question

Dennis Taylor

I seen on pbs channel on the Woodturning show, he turned a ornament out of a 2" shipping tube, used veneer, I found the article in Woodturning design Winter 2006, not sure I understand how to lay out and figure width of each piece of veneer.....can someone explain it?...Dennis

Re: Xmas Ornament Project question

#2

Tim Boger

Re: Xmas Ornament Project question

Tim Boger

Hey Dennis,

I turn ornaments now and then but have not seen what you're referring to .... can you provide a link to what you're wanting to make.

Re: Xmas Ornament Project question

#3

Ken Vaughan

Re: Xmas Ornament Project question

Ken Vaughan

http://www.davidreedsmith.com/Articles/TubeOrnament/TubeOrnament.htm

This the one you were referring to??

If it is, there is an addendum with more information

http://www.davidreedsmith.com/Articles/TubeOrnament/TubeOrnamentAddendum.htm

Hope this helps.

Re: Xmas Ornament Project question

#4

Re: Xmas Ornament Project question

Dennis Taylor

I have included in this post, a link to the Original maker of this style of tube ornament, he uses a shipping tube for the bulk of the center, he posts on this site, so maybe he will see and respond:

http://www.davidreedsmith.com/Articles/TubeOrnament/TubeOrnament.htm

Dennis