Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Thread chasing problem

Posts

Thread chasing problem

#1

Thread chasing problem

john lucas

I've been trying to chase threads in epoxy. I had this problem twice now and don't know what is causing it. I haven't had this problem with any of my wooden threads yet but that doesn't mean it won't happen.

I fill a groove with epoxy for the lid and for the male threads I put tape around the bottom and fill that space with epoxy. Then I can turn this down to size for the male and female threads.

I check that the face of the box is square. I check the sides of the epoxy so it's parallel to the lathe bed before threading. You would think every thing would line up but when I screw them together the lid goes on crooked. See the gap in the photo.

Any guesses as to what's happening.

Re: Thread chasing problem

#2

Steven Antonucci

Turn a bead there :-)

Steven Antonucci

I'm guessing it's a small error being magnified over a distance. If you thread deeper or shallower and the error grows or diminishes, that's it. If not, check the bottom of the female thread to se if there's a small chip or something lodged in the epoxy.

s

Re: Thread chasing problem

#3

Re: Thread chasing problem

Dick Coers

My first thought is that the peak of the threads may be square to the face, but the pitch diameter may not be. Are the threads all the same depth?

Re: Thread chasing problem

#4

Richard Allen

Re: Thread chasing problem

Richard Allen

My guess, and this is a WAG, is that the threading is tight and very precise. With a little slop in the threads the threads would take up the slop as the lid is tightened onto the base of the box.

Re: Thread chasing problem

#5

Re: Thread chasing problem

john lucas

Dick I put the inside threader and outside threader together to see if the teeth matched. They do almost exactly with each tooth seating to the bottom of the other. That was my first thought, that the teeth were off on one or the other. Putting a thread pitch gauge on them shows no errors either.

Re: Thread chasing problem

#6

Re: Thread chasing problem

john lucas

There is a mild amount of slop but not much. However when the wood touches there isn't enough slop to force the gap closed.

I put a square on them. I could not check the female threads very accurately because you just can't see light down in there. the male threads are dead on square to the shoulder of the box.

Re: Thread chasing problem

#7

Re: Thread chasing problem

robo hippy

I don't know if you are hand chasing or using a cutter like the Bonnie Klein or Baxter. I had this problem a few times, and if I remember correctly, it was from the threads not going far enough down (male threads I think), so that the threads bottomed out, or stopped, before the lid was all the way down, and if you can cut another half revolution or so in the male part, it should go all the way down. I hope this translates. Could be in the female part as well if the threads are not cut far enough down. It causes the lid to seat on the threads, rather than the shoulder of the box.

robo hippy

Re: Thread chasing problem

#8

Re: Thread chasing problem

john lucas

Reed I'm hand chasing these. I don't think I've ever had the problems when using the Baxter threader. I did check to see if the male threads were too long. That isn't the problem. I have had a problem with making the recess behind the male threads too long. Then when you screw the lid on it clears the female threads and just spins.

Re: Thread chasing problem

#9

Re: Thread chasing problem

Dick Coers

John, I was thinking that maybe the pitch diameter was not square to the face. That somehow you angled one of the threads slightly, maybe not cutting to full depth, and that the lid was following the angled pitch dia into the box. No idea if you can even cut a thread like that, just thinking.