Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

How do you handle this?

Posts

How do you handle this?

#1

How do you handle this?

Mike Jones in Redding, Ca.

A fir burl cap with bark inclusions over 1/3 of the surface area (and nice swirley grain around it) with some sanding needed to finish. The bark areas are, of course, very soft in comparison to the sound wood that surrounds it. These bark areas are very irregular in shape, and sanding just up to the margins is just not resulting in a level surface. I'm thinking: coat the whole thing with CA to harden the bark...and hope for the best. Any other suggestions?

Re: How do you handle this?

#2

Re: How do you handle this?

Sean Troy

Depends how big the cap is. With a reasonable size that you are comfortable with, I would speed up the RPM's as fast as you feel comfortable, use a 3/8 bowl gouge freshly sharpened with a swept back grind. Do a very light push cut all the way through the distance and hold the handle low against your body while doing the push cut. Resharpen and do again until you get your desired look and feel. I have always had good luck that way even on pine burl caps.

Re: How do you handle this?

#3

Re: How do you handle this?

Doug Turner

Some people remove the bark with a pressure washer and leave the rough surface natural - especially on burl caps.

Re: How do you handle this?

#4

Re: How do you handle this?

Norm Smith

Mike, When I want to save the bark, I do as you suggest. Soak it with thin CA glue.

Norm

Re: How do you handle this?

#5

Re: How do you handle this?

Bill Neddow

On soft woods like this with bark inclusions I always use Polyall 2000. You will think you are turning a solid piece of Hard Maple after the treatment. Mix it, brush it on, and it is dry in 3 minutes. It will soak in 1/8 to 1/4 inch -- so if you turn more than this away, you may need another coat. It is a 2-part epoxy and I have kept the unused material for up to two years in as refrigerator. I have yet to find a wood that it stains, like CA glue.