Stop Collars
Ralph
The recent posts on stop collars (and the OP going to McMasterCarr, a firm I endorse and have for 30 years) reminded me that I really needed some stop collars for my tool rest, so...
Since my tool rest's post is 0.995 inches, I knew I could use 1inch EMT. So I took a piece from the stack, grabbed the tubing cutter and cut lengths off. I cut several in lengths from 1-1/8 to 1-3/4 in 1/8 steps. A little file work to clean the ends and...
Now to decide if 1/8 inch steps was enough, or if I need to go back and cut more in 1/16 steps





