Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Bill Hale's Poly Fill

Posts

Bill Hale's Poly Fill

#1

Bill Hale's Poly Fill

adrien

Finally got around to using the very neat sample package Bill Hale sent me.

It's rather neat stuff: starts out water thin, ends up quite solid.

On the piece I was experimenting with, I started with it quite thin and it ran out the

bottom of the crack, so I should've taped it over first. But that meant the whole hollow

area was filled. Once hardened, it sanded and finished well. With the prospect of

colored poly, it could make a replacement for Inlace....

Re: Bill Hale's Poly Fill

#2

Re: Bill Hale's Poly Fill

john lucas

Adrien Let me know how it looks in a few days. My first one seems to have expanded slightly. There's a little bump there. I'm going to try to sand it flush tomorrow and see if it stays that way. I'm not sure what caused it because it almost felt low when I first finished sanding.

Re: Bill Hale's Poly Fill

#3

Re: Bill Hale's Poly Fill

Bill Hale The Wood Spinner

John

Was the working piece fully dry. It may have shrunk a little and compressed the Poly.

Does any one else have any reports on how you like the stuff.

In the instructions I noted that you need to back tape due to run through. You can also add stone to the poly after you pour it.

As of this date I am having problems with formulation and quality controll on the clear Poly. When I am satisfied I will let all know.

I would sure like to hear your thoughts on this stuff.

Re: Bill Hale's Poly Fill

#4

Re: Bill Hale's Poly Fill

John Lucas

Bill That bowl was cherry and should have been as dry as my shop can get. This time of year that means there's a fairly high moisture content. After the bowl was finished I took it into the house which is air conditioned. That would lower the moisture I'm sure. That's probably where the problem occured unless the polyfill is a water based product. I'm guessing the bowl probably shrunk a little which compressed the polyfil and pushed it up. That's a guess of course.

so far what playing I've done tells me this is a fun product to play with. I don't have enough experience with it yet to say I like it better or worse than epoxy and Inlace. I'll certainly let you know as learn more about it.

One thing I do like. It is water thin at first so it seeps into the tightest area of the crack or defect. Then it hardens fairly quickly. I haven't actually done a test to see how soon you can start turning. I let is sit overnight simply because that was convenient.

If you repair a bowl that is turned very thin (1/4" or less) the black polyfil might appear a little greenish. A little more black dye might not hurt if it won't change the working characteristics. As long as the bowl is 3/8" or thicker I don't think you would see that. In my 1/2" thick bowl it's very black looking. I'm going to turn a thin bowl and use the polyfil so I can see how it works and looks on a thin piece.

Re: Bill Hale's Poly Fill

#5

Re: Bill Hale's Poly Fill

Bill Hale The Wood Spinner

The colorant you need to use can NOT be water or oil base.

What they recommend is called Polyol but I can not find a source for it. As said, if it is thin it is not as black. Lamp black may work but am not sure.

Bill

Re: Bill Hale's Poly Fill

#6

Re: Bill Hale's Poly Fill

Brent Smith in Montreal

I believe you may be able to source these colorants through automotive body shop suppliers.