Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

OT Vacuum pump rebuild from printing press

Posts

OT Vacuum pump rebuild from printing press

#1

OT Vacuum pump rebuild from printing press

BTF

The time has not come yet to take the pumps from the old multi 1250 printing presses to be used for there next purpose of vacuum chucking. I still it to run the press.

Unfortunately, the Gast rebuild kit I purchased didn't come with instructions nor does the supplier have directions.

I've removed the 8 or so screws from the side plate expecting it to easily come off and expose the worn/damaged vanes. No such luck. Not really sure if I should pull harder or pry it off. Or to start to remove the nut on the shaft and then deal with the bearings.

I'm wondering if anyone here has walked this trail and has some suggestions as to the best way to proceed.

Thanks to anyone who can shed some light on this.

Bruce

Re: OT Vacuum pump rebuild from printing press

#2

Call Gast

Dave Peebles Lyons, Ohio

Hi Bruce,

I have not had to replace mine, but I have heard really good reports on how helpfull the people are at Gast.

I am sure they can walk you through it.

Good luck,

Dave

Re: OT Vacuum pump rebuild from printing press

#3

Re: Call Gast

BTF

Dave,

I'm embarrassed to say that that thought hadn't occurred to me. I did go there site, but didn't find anything helpful.

Will give them a try.

Thanks.

Re: OT Vacuum pump rebuild from printing press

#4

Re: Call Gast

Ron Sardo

Dave, do you have a phone # for Gast?

Re: OT Vacuum pump rebuild from printing press

#5

Gast phone number

Dave Peebles Lyons, Ohio

Hi Ron,

Here is the one I have,

Technical Phone: 269.926.6171

Dave

Re: OT Vacuum pump rebuild from printing press

#6

Rob Wallace

Re: Call Gast

Rob Wallace

I re-conditioned a Gast 0523 vacuum pump that I had gotten off of eBay about 4 years ago, and the person I spoke with at the Gast support line was really helpful and directed me to specific pages of their web site to help with dismantling and re-assembly once I had cleaned out all of the various ports and filters. I think they also sent me a pdf of an exploded parts diagram - I can vouch for good customer support. (Excellent pumps... I have three of them!)

Rob Wallace

Re: OT Vacuum pump rebuild from printing press

#7

Re:  Gast phone number

Ron Sardo

Thanks Dave