Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

What's this/how was it made?

Posts

What's this/how was it made?

#1

What's this/how was it made?

Scott Blundell

A friend showed me something recently that looked a lot like this but was made entirely of wood. The ball turned in the cup and it seemed to be made of 2 types of wood, a lighter one for the ball, darker for the cup. The only thing she knows about it is that it is "old and rare". She asked me what it was used for and how it was made. I was stuck on both counts. The ball was definitely captive in the cup and the fit was quite tight, the overall size was about 3" diameter with a 1 1/4" ball diameter. The ball rolled very smoothly in the cup, but there was very little play in the fit.

Re: What's this/how was it made?

#2

Re: What's this/how was it made?

Bill Howatt

The picture appears to show non-directional rollers that are often used in out-feed tables of table saws or other machines to support the workpiece as it comes off the machine. Since the balls can roll in any direction they do not "pull" the stock off its intended direction. Long cylindrical rollers only roll on their axis and if they aren't perfectly lined up will tend to pull the workpiece in a direction perpendicular to their axis.

I assume the wooden one does the same function but maybe it sits in on a water/moisture source for moistening stamps, envelope flaps?????

Bill

Re: What's this/how was it made?

#3

Re: What's this/how was it made?

Dave Belser

Scott - I assume that you are just talking about a captured sphere. I recently read a description about how to make them somewhere but don't remember where. The basic idea was to get the fit just tight enough that you can hit the sphere with a solid tap and it pops in without breaking anything.

If I remember where I was reading about it I'll post it.

- Dave

Re: What's this/how was it made?

#4

Re: What's this/how was it made?

Doug Turner

David Springett gives instructions for a tear drop shaped beaded ball that looks like the head of a knight's mace weapon, and in another book a wedge of cheese with a tear drop shaped mouse sticking out of it.

The secret is to turn a hole slightly larger than the ball,then undercut the hole to slightly larger than the diameter of the ball leaving a tapered edge about 1 mm thick. The ball is press fit into the hole and the wood flexes just enough to allow entry of the ball and then snaps back to shape.

Might take a little trial an error on the first one or two.

Re: What's this/how was it made?

#5

Re: What's this/how was it made?

John K Jordan

I read once of a method - can't remember the details but I think they made the captured part from dry wood and the outer part from green which shrunk when dried.

Re: What's this/how was it made?

#6

That's it Doug,

Dave Belser

I bought David Springett's book a few months back.

Re: What's this/how was it made?

#7

Re: What's this/how was it made?

Scott Blundell

Thanks to everyone for the information. I expected there was no "magic", but it did not seem likely that there was a "press fit". I expect the wet dry trick was implemented, but there was no noticable warping of the base.

Re: What's this/how was it made?

#8

Ball And Socket  *LINK*

charlie belden

I did some playing with the Ball and Socket idea to do "swivel joints" for an articulated beads chain and a penduluming finial on a lidded box. If you can turn a sphere and concave hemispheres it's not hard to make what you're describing. If turning concave hemispheres is too difficult - use a half round router bit and a jacobs chuck to make them. The attached link illustrates the idea and methods of making swivel joints.


Swivel Joint Making