Ambosia Maple box
SteveP
This was made from a piece of wood someone called scrap. I tried to do it justice. Bob M. thank your source for the nice piece of wood.
Photographer I am not

Knowledge You Can Build On — Est. 1998
Ambosia Maple box
SteveP
This was made from a piece of wood someone called scrap. I tried to do it justice. Bob M. thank your source for the nice piece of wood.
Photographer I am not

Re: Ambosia Maple box
Mike Stafford
Steve, that is a great looking box however I wish the angle of viewing was slightly different so that we could see the shape a little better.
Does the lid overfit a tenon or is it a "stopper fit"?
Great grain alignment and a nice looking finish.
Re: Ambosia Maple box
SteveP
Mike,
I took a few shots with my phone so they are low quality but you should get a better idea of the shape
Steve

Re: Ambosia Maple box
Mike Stafford
Thanks Steve, it is much easier to understand the shape.
The only recommendation I would make is lift the maximum diameter of the bottom, i.e. make it a little higher in the box. If you were to locate the maximum diameter of the body so that it occurs approximately 2/3 of the way from the bottom it would drastically change and lighten its overall appearance. The box would appear less squat and the mass of the body would be closer to the mass of the lid resulting in the lid appearing less dominant in appearance.
You did a good job in finishing the lid with a slightly smaller diameter than the body. That also helps lighten the heavy appearance of the lid.
I know you did not ask for anyone's opinion but I think you turned a very nice box and I was just offering some suggestions for your next one.
Re: Ambosia Maple box
David Walser
Mike,
Thank you for offering Steve those suggestions. I learned a lot from them.
Steve,
Thanks for posting pictures of your box. I think it's very well done.
Re: Ambosia Maple box
SteveP
Mike,
Thanks for the great suggestions. Can't learn without good constructive feedback