Platter for parent's 50th
Craig Daymon
I borrowed time in a friend's shop to make this platter. It's 17.25" in diameter. I haven't done much turning in the past 2 years, being confined to a 1 bedroom apartment, so it was a bit of a challenge. I burned the dates into the front lip and the dedication into the back. Had some headaches with finishing it, but since my finishing room is the living room of the apartment, maybe it was just the fumes.
I like turning platters. I wasn't taking any big chances with this one, but I like their ability to show off good grain patterns and the potential for getting creative on the lips. If the figure was plainer, I would have considered carving or burning something more than the dates on the lip of this one.

I like putting a button in the middle of the back equal in height to the outer bead. My thinking is that it provides support in the middle if anything of weight is sat on it. (Possibly a non-bead base wouldn't require this.) I'd rather the button had more character than what I put on this one. The next one will be better. Does this button idea make sense or am I wasting effort on it.

In the one picture, you can see a bark inclusion. Most of that was filled with Gorilla epoxy mixed with Strait-line snap-line chalk, black/permanent. It worked pretty well and the chalk is cheap. Did have to hit it with a heat gun to get it setting though.
The folks will get the platter on Sunday. Don't tell them about it, it's a surprise.
Questions and comments welcome.
-Craig





