Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Question about storing spalted Maple

Posts

Question about storing spalted Maple

#1

Question about storing spalted Maple

ted evans

I have a good bit of Maple in various stages of spalting from initial stages to advanced. The tree was cut late last summer and most of it has been on the ground until recently. Due to my restricted time for turning, it will be many months before I can work on more than a few pieces of this wood. I plan on coating the ends with Anchorseal and storing the wood on pallets in my basement. My question is, stored in this manner, will the spalting continue, slow down or stop?

Thanks for your input and suggestions.


Re: Question about storing spalted Maple

#2

JL

Re: Question about storing spalted Maple

JL

"My question is, stored in this manner, will the spalting continue, slow down or stop?"

The answer is - it depends. If the wood is still "wet" and quite damp, the spalting may continue. If you coat it and seal in the moisture, it will still have somewhat reasonable spalting conditions.

Spalting basically occurs when a fungus is introduced into a tree (or log section). The fungus (and the dark spalting lines) is carried through the tree (or log section). So long as conditions are fairly optimal for growth and transport of the fungus - it will continue. You eventually want it to stop - before the wood gets too punky and soft.

I prefer to dry it a bit.

Re: Question about storing spalted Maple

#3

Re: Question about storing spalted Maple

ted evans

Thanks for the info JL. How do you approach the drying process? Would storing it on pallets off the ground and covering it be suitable? Your suggestions?

Thanks

Re: Question about storing spalted Maple

#4

Re: Question about storing spalted Maple

Dick Coers

If you store it in the basement without some air movement, it's going to get grow mold. And not the good kind. The spalting will stop, but it's going to get real fuzzy. It's better to store it in a shed, out of direct sun light, that has some air movement. End coat as planned.

Re: Question about storing spalted Maple

#5

JL

Re: Question about storing spalted Maple

JL

I don't usually do wood chunks. I'm a furniture maker, not a bowl maker.

However - typically I support my wood in stickered stacks with a reasonable air circulation. I coat the ends to prevent rapid drying. If you were to put your chunks on pallets (off of the floor) and coat the ends, you'll have a slow drying process. You might want to give them a wash with some water with a little bleach to slow down surface mold.