Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Serious prototyping :-)

Posts

Serious prototyping :-)

#1

Steven Antonucci

Serious prototyping :-)

steven antonucci

I had this idea for this vessel based upon a log that my buddy Tony had shown me. A few weeks back, he and I dragged some of it out of the woods and muscled it up into my truck. I should have gotten it up off the ground because it started to spalt, but I think I will be able to bleach it.

The ash tree grew in Rockaway, NJ. It was the whitest ash I had ever seen. Sadly, this piece had the surprise bark inclusion, so I made due. I split it out of the log on Friday in 4 quarters. Yesterday, I went at it...


I'd like to tell you that it's 1/8" thick all the way down and cut through that 1/2" hole, but you'd know I was lying :-) It's actually made in two sections, and the split is in the lower bead. I hollowed it to about 3/8" +/- in about an hour using a large hook tool on a homemade 3/4" bar. It's about 18" deep, and I was pushing the limits of the reach of that bar.

Glued the top section last night after cutting myself on the rim of the vessel (my hands are taking a beating lately...), and finished it in about 20 minutes this AM.

The real one will be 1/8"-3/16", and the difference will probably be 3x the time. This took about 2 hours or so after the log was quartered...

Comments welcome.

Steve

Re: Serious prototyping :-)

#2

Re: Serious prototyping :-)

Texian

Mighty fast work Steve (by my standards at least). Looks good from here; smooth curvature w/ no flat spots (sometimes difficult with very shallow curvature); might have made the base a tad smaller diameter.