Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Help needed--slightly OT

Posts

Help needed--slightly OT

#1

Help needed--slightly OT

Dinyar Chavda

I have a Proxxon jigsaw that plugs into one of the Proxxon Heavy Duty Transformers (NG 5/E) that can accommodate 3 tools. I had the jigsaw plugged into one of the sockets, and I must have bent it somehow, with the result that the negative prong on the 3 prong plug broke off and is now in the transformer socket (and I cannot get it out). I don't care that that particular socket is unusable, but I want to be able to use the jigsaw. So, my question is what kind of a plug is that, where does one find a replacement, and how does one attach the replacement plug. I assume that having the broken prong in one of the sockets is not dangerous.

A picture of the broken plug is below:

TIA.

Re: Help needed--slightly OT

#2

Re: Help needed--slightly OT

Bill Turpin in WNC mountains

Your plug appears to be actually two wire. The third prong is offset to insure proper polarity. I would approach Proxxon about a replacement plug. The only possible error with replacement would cause wrong rotation direction. Easily switched.

Drastic repair: Cut the male plug and � 6 inches of wire off of another tool. Then purchase male/female plug sets that are available locally. Discard the broken male plug. Install female on six inch of wire and new males on your two tools.

I would place electrical tape over the broken, non-removable pin.

Re: Help needed--slightly OT

#3

Re: Help needed--slightly OT

Dinyar Chavda

Thanks, Bill, for both your ideas. Proxxon came through (an very promptly), and I bought a replacement cord from them. Hopefully, I can install it without messing up the tool!