Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Disk Sander

Posts

Disk Sander

#1

Disk Sander

Larry

What is a good speed for a 12" Disk Sander?

Re: Disk Sander

#2

Re: Disk Sander

Dave Peebles Lyons, Ohio

Hi Larry,

I have a 12" factory built disc sander that runs at 1725 rpm. It seems about right to me.

Dave

Re: Disk Sander

#3

Re: Disk Sander

john lucas

The speed of mine is also 1725 but If I built one from scratch I would put a variable speed motor on it. When you sand woods like Cherry it is way to easy to burn it. I try to sand near the middle which has a much slower surface speed but you just can't always do that.

My first tool was a Shopsmith and it had variable speed. I really enjoyed using the sanding disc on this tool because you could really slow it down. 500 rpm if I remember correctly.

Re: Disk Sander

#4

Re: Disk Sander

bill crommett

My disk sander is a dedicated Shopsmith and I have no idea of the present speed, but I have done lots of cherry and not burned any of it -- yet.

Re: Disk Sander

#5

Re: Disk Sander

Texian

Definitely variable. I frequently run my 15-1/2" disc at 150 to 250 rpm for sanding the ends of segmented half rings.