Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Turning cabinet knobs / drawer pulls

Posts

Turning cabinet knobs / drawer pulls

#1

Turning cabinet knobs / drawer pulls

Chris Hoehle

Greetings all, I've been a long time follower of this forum and have learned so much from you all so I thought I would post this and see what you have to say. I mostly turn hollow forms and bowls, so this is somewhat new territory for me.

What method do you prefer to turn cabinet knobs or drawer pulls? I've got some of the #8-32 brass threaded inserts and so far, I'm thinking I will start between centers with a 1 1/2" x 2" or so blank, turn a tenon on each end, then put one end in the chuck and drill my hole for the brass insert in the other end. Then, I'd flip it around and put the other end (now with the hole) in the chuck, finish turning, and part off.

The other idea that occurred to me would be to make a mandrel by bolting an #8-32 screw through a piece of plywood attached to a faceplate.

Are there any other methods that you like to use that might be more efficient?

Re: Turning cabinet knobs / drawer pulls

#2

Re: Turning cabinet knobs / drawer pulls

Cyril Griesbach

Chris, I doubt that a #8-32 screw would have enough holding power for turning the knob and especially in plywood.

Re: Turning cabinet knobs / drawer pulls

#3

Small screw chuck

Doc Green

Chris, make a small screw chuck with an 8-32 screw. Then after you install the insert in the blank for the knob, screw it onto the screw chuck and you'll be good to go. Epoxy the screw into the screw chuck so it doesn't come loose when you go to unscrew the finished knob. ~Doc


Re: Turning cabinet knobs / drawer pulls

#4

Richard Allen

Re: Turning cabinet knobs / drawer pulls *LINK*

Richard Allen

Oneway makes a small screw chuck which is made exactly for the purpose you have.

Forget the brass inserts, decide on the screws you want to use and use that screw in the screw chuck.

You will be surprised by how quick and easy the process is.


Oneway screw chuck

Re: Turning cabinet knobs / drawer pulls

#5

Re: Turning cabinet knobs / drawer pulls

john lucas

The first turning I ever did was with an electric drill and a screw chucked up in it. I turned some cabinet knobs. That is still the method I use but now I use a piece of wood with a screw epoxied in and put that in my chuck.

Re: Turning cabinet knobs / drawer pulls

#6

Thanks for the help everyone!

Chris Hoehle

I will give the screw epoxied into a block of wood approach a try.