Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

sort of OT: need help fixing Makita electric c/saw

Posts

sort of OT: need help fixing Makita electric c/saw

#1

sort of OT: need help fixing Makita electric c/saw

ILYA Z

Does anyone have experience fixing Makita electric chain saws? I have the 16" model UC4030A (http://makita.com/en-us/Modules/Tools/ToolDetails.aspx?ID=25942) I installed a new chain on it the other day. Followed all the instructions (http://makita.com/en-us/Assets/Images/Products/UC4030A/owners_manuals/UC3530A,UC4030A%20manual.pdf), or at least I think I did. The very 1st time I used it with the new chain, the chain came off of the blade after about a minute of cutting.

I took off the cover and tried to reinstall the chain. To do that I turned the chain tensioning screw (pg 9 of the manual) to adjust the tensioning pin. At some point I discovered that:

1. The pin is stuck in one corner and does not move.

2. The plastic cover next to the pin is broken (see photo)

3. The two bevel gears that are supposed to rotate when I rotate the tensioning screw are stuck and do not turn.

So questions:

1. How did the plastic cover break?

2. How do I get the gears to turn?

3. Other than the broken cover, what else might be wrong there and would need to be repaired or replaced?

Thank you!

Re: sort of OT: need help fixing Makita electric c/saw

#2

Re: sort of OT: need help fixing Makita electric c

D. Hansen

I'll bet you inadvertently set the brake. When the kick back brake trips the saw will not move. Pull the handle back and see if it clicks. If it does your chain should be able to be moved. as for the adjusting screw. It was put on with some sort of gunk that holds the pin on the shaft. If you screw it too far the gunk might have "frozen" the pin.

Re: sort of OT: need help fixing Makita electric c/saw

#3

Re: sort of OT: need help fixing Makita electric c

Roy Girolami

I don't have a Makita chainsaw, but I do have a Milwaukee. Whenever you put on a new chain, if the old chain has been on a while, the sprocket will be worn and the new chain might slip. I always start with 2 chains and when they need replacing, also replace the sprocket.

In terms of the broken part, I would advise taking it to a repair center and get their input.

Roy Girolami