Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Question on platter blank/Feather

Posts

Question on platter blank/Feather

#1

Question on platter blank/Feather

Barry Irby

I had a arborist bring me some pieces of oak from a neighbor's yard. Told him I would like a couple of crotch or branch union pieces with the "Y" in them. He obliged, but when I cut one open I found there was little or no feather and a long thin (1/8 to 1/4") bark inclusion running almost full length. The question is about the Bark. I think it has No Strength and if I turn the blank and leave it in the player (all the way through) the blank will fall apart or certainly fail along the line. Am I right on this? Is the blank worthless?

Re: Question on platter blank/Feather

#2

Re: Question on platter blank/Feather

Tery Scott

More than likely you will end up with 2 pieces as the seem or were the 2 branches have grown separately then come together may appear to be stuck together will have an invisible weak point .I wouldn't risk it myself

I have turned the inside first then added biscuits or butterfly's with my biscuit jointer in a contrasting wood .But being wet glueing can be a problem

Re: Question on platter blank/Feather

#3

George Balock

Re: Question on platter blank/Feather

George Balock

Barry,

Tery is correct. It probably was where two branches grew so close they grew together. It's firewood.

George

Re: Question on platter blank/Feather

#4

Re: Question on platter blank/Feather

Dennis Ford

This is common with crotch sections where the branches come off at an acute angle. If you get a large piece like this, try cutting it through the bark inclusion instead of through the piths. There will usually be a lot of figure on each side of the bark inclusion. The figure will not be deep so this only works for platter shapes