Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Hello all of you Jet 1642 owners.

Posts

Hello all of you Jet 1642 owners.

#1

Hello all of you Jet 1642 owners.

ted evans

Last summer I purchased a Jet 1642 EVS 2HP lathe, which I have not had a lot of time to turn on. However, there seems to be a problem developing with the lathe. Some weeks back, I noticed an intermittent clacking noise coming from the motor at speeds below about 800 rpm. This problem has gradually worsened until the clatter is now present up to about 1900 rpm or so. Beyond that speed, it is quite and runs very smooth; below that speed, it becomes noisy and has vibration.

Adjusting the belt from tight to loose to no belt, makes no difference. The motor shaft appears to run eccentric, although I have not put a gauge on it. Does this sound like a bad bearing or some other problem? Have any of you experienced a similar problem with your 1642?

Thanks for your comments.

Ted

Re: Hello all of you Jet 1642 owners.

#2

Re: Hello all of you Jet 1642 owners.

Ed Moore in SW VA

On the PM3520 there is a set screw on the pulley that sometimes gets loose and drives PM owners nuts. Check your pulley and try and tighten the set screw(s) on it.

Ed

Re: Hello all of you Jet 1642 owners.

#3

Re: Hello all of you Jet 1642 owners.

Jeff Rich

There are a couple of things I checked when my lathe started clicking or rubbing...

Loose set screw on the pulley

Loose speed indicator sensor

belt too tight...

and lastly...bad motor

Mine was a bad motor.

Re: Hello all of you Jet 1642 owners.

#4

Re: Hello all of you Jet 1642 owners.

John K Jordan

Mine certainly does not run eccentrically, but I did have a clicking sound. My clicking went away when I cleaned out some accumulated sawdust that was packed in the fine grooves on the inside of the belt. The sawdust made a noise each revolution. Not saying this is your problem but might be worth a look.

JKJ

Re: Hello all of you Jet 1642 owners.

#5

Re: Hello all of you Jet 1642 owners.

Scott Hurley in N VA

I had the same issue - it was the set screw on the pulley. I tightened the screw and the noise went away. That was at least 2 years ago, and it hasn't done it again.

Scott

Re: Hello all of you Jet 1642 owners.

#6

Re: Hello all of you Jet 1642 owners.

Dale Bright

Ted, there is a known issue with a bad batch of motors. Just call the Jet customer service people and they will send you a new motor. I am on my 3rd motor. The first replacement was noisy out of the box and they were very good about shipping out a new one.

Re: Hello all of you Jet 1642 owners.

#7

Re: Hello all of you Jet 1642 owners.

ted evans

Hello all and thanks for your comments/suggestions. It ended up being a bad motor. Gary at Jet customer service listened to the noise and said that he had that noise before....from his personal machine. He will send out a new motor.

Ted