Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Finish help - long

Posts

Finish help - long

#1

Finish help - long

Don at Central Illinois

I just completed a HF from spalted Hackberry. It was a little too spalted and my small opening had to have a design enhancement. I rubbed on tung oil, 3 - 4 times and let dry. I then used the Beal buffing system with the carnuba wax finish. I am very disappointed with the luster, or lack of. The bottom part is heartwood and the grain is fine. The top is sap wood, with the spalting showing and looks very dull. Since I have the carnuba on, what can I do to make the sapwood shine more? I'll try to post a photo tonight. Thanks in advance for any help.

Re: Finish help - long

#2

Re: Finish help - long

fgvanatta

Here's what I would try: Put on a couple of light coats of shellac (I use SealCoat cut 50/50 with alcohol), sanding to 600 or using white non-abrasive cloth in between. Then, just a dab of light oil (mineral oil or BLO) all over, rub in with a paper towel or soft cloth until you don't get any more oil residue on it. Then another coat of light shellac, buff with white non-abrasive, then go back to the full Beall system (tripoli, white diamond, wax).

This usually works for me. The shellac seals some of the pores to provide a smoother base for the buffing system and also prevents either the brown tripoli or white diamond getting in the pores and causing spots. The oil will pop the grain a little and also make the shellac a little shinier/smoother.

Frank

Re: Finish help - long

#3

Re: Finish help - long

Skip Beardsley

Don,

In addition to shellac or sanding sealer I would add one step to the above solution. After sealing and sanding to a least 600 I would turn the speed up as high as you are comfortable and burnish with shavings or a brown kraft grocery sack. The latter is a trick Russ Fairfield told us about when he came to our club to do a demo. I now use it all the time and the results are well worth the extra step.

Skip

Re: Finish help - long

#4

Re: Finish help - long

GaryG in MD

The above answers are good...

OR you could just wipe it down with mineral spirits to get the wax off and then put on as many of coats of wipe-on poly or Waterlox until you get the build you desire. If it's too shiny, take it back with Abralon -- 1000 will give you a nice satin finish -- 4000 will bring up a nice, non-plasticy shine. ...Gary