Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Grinding wheel modification

Posts

Grinding wheel modification

#1

Grinding wheel modification

Galen Vetterick

I just put the Oneway balancing system on my Woodcraft grinder. I had to also replace the griding wheels to provide for the 1" hole.

I always hate to have unused parts setting around.

Has anyone attempted to use a masonary carbide bit and open the 5/8" hole to 1" ???

It seems like with a slow speed and light pressure it could be done and not worry about any fractures.

Could even epoxy line the hole to support the grain.

I should have tried before buying the other wheels but I just found my 1" carbide bit and wondered if I wasted money on new wheels.

I know it will be years before I need new wheel now so may just find someone that has gray wheels and would like to have the white.

Now it's just a pole to see if the drilling has been done by anyone.

Galen

Re: Grinding wheel modification

#2

Re: Grinding wheel modification

robo hippy

I have done a lot of drilling in concrete, but not so much the masonry. My guess is that you would not get a very consistent diameter with those bits, and would get a lot of wobble. Also as you said, there would be risk of fracturing the wheel.

robo hippy

Re: Grinding wheel modification

#3

Dick Hines

Re: Grinding wheel modification

Dick Hines

I would not enlarge the hole in a grinding wheel. If you got a crack that could not be seen you could have BIG trouble when it came apart while running. It's no telling where the thing could go.

My grand father had one blow up on him while sharpeing a saw blade and we found parts of the wheel all over the shop. He was lucky he did not get hit. He did this for a living and still things went bad.

Re: Grinding wheel modification

#4

I Agree - too risky for little gain

Bill Howatt

Re: Grinding wheel modification

#5

Re: Grinding wheel modification

Bill Neddow

Grinding wheels are cast and are not meant to be drilled or otherwise modified. You will likely end up with a microscopic crack and will not even be aware of it until the wheel explodes. You risk losing your whole face in the explosion.

Re: Grinding wheel modification

#6

Re: Grinding wheel modification

Keith T

Plus...when you grind, the stone wears away the steel. The stone is harder than the steel..so, when you try to drill the center of the stone, you will destroy the drill bit while ruining the stone.

Re: Grinding wheel modification

#7

Re: Grinding wheel modification

Bernie Weishapl

My dad brother did that to a stone. He thought it would be simple to enlarge the hole from 1/2" to 5/8". One month later he lost 3 teeth and 23 stitches when the wheel exploded probably due to a crack he caused.