Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Ulu or Mezzaluna

Posts

Ulu or Mezzaluna

#1

Ulu or Mezzaluna

bill crommett

I have been commissioned to turn a bowl/block for an Ulu, and I wonder if any one has any experience in the design of the bowl/block. My big question is : Should the contour of the bowl mimic the radius of the Ulu blade or should it be bigger, and if so by how much ?

Re: Ulu or Mezzaluna

#2

Re: Ulu or Mezzaluna

Jeff Willaford

I can't speak to the official specifications but my bowl has a larger radius than the ulu (to hold more) and is a relatively deep bowl (to hold more). It works for me.

Re: Ulu or Mezzaluna

#3

Re: Ulu or Mezzaluna

bill crommett

Thanks, Jeff. I was considering your radius, but was determined to not make any gross errors. Thus the question.

Re: Ulu or Mezzaluna

#4

Re: Ulu or Mezzaluna *LINK*

HeatherAinAK



Pictures are from the www.theULUfactory.com and ulu.com

Many of the custom ones I see here in AK are about 10" diameter (the interior diameter) and very thick walls and bottom but not very deep, 1.5-2" depth. Many are square with straight sides, like a cutting board with only the interior profiled. The round ones have either straight sides or at least a very wide base, like 90-95% base to sides ratio. They look like a bowl turners worst nightmare but you need the heft and wide base.

My mother-in-law has one from walmart (pretty lame since I am a woodturner) and she loves it. She has had a stroke and limited use of one hand. With the ulu and the bowl she can cut up veggies and not have them flying around the cutting board.

Craft supply has a pdf on making these.

Heather


craft supply pdf

Re: Ulu or Mezzaluna

#5

Re: Ulu or Mezzaluna

bill crommett

Thanks, Heather. Both links were informative.

Re: Ulu or Mezzaluna

#6

Re: Ulu or Mezzaluna

Don Evans

If the person using it does it correctly then it doesn't matter about the radius.

One end of the blade should touch the bottom of the bowl or block and then it is rolled along the bottom, picked up and repeat. It can be, but really isn't designed to just chop with a down and up motion.

Aren't these originally skinning knives?

We have one that I designed and made a holder for it using the curve of the blade in the design. These things are really sharp, much too sharp to be put in a drawer.

Don