Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Rocky Bowl 7

Posts

Rocky Bowl 7

#1

Rocky Bowl 7   

Tery Scott





Or as Id like to call it Hard as hell

This piece of Coolabah sure was hard ,it didn�t mater what brand of chisel I used but the bowl gouges just couldn�t hack the hardness . They lost there edge after a few seconds some even chipped in areas were at some stage I had over heated when sharpened .

This was a $95 burl so I wanted to save as many pieces off it as I could this included 6 rings for mirrors or inserts ,Smaller bits for pens ,wine corks .I probably wont use any of the scraps as I just don�t do small but at least when I give away to woody mates that do Ill be able to say I recovered the burl cost (in my dreams anyway )

I couldn�t or wouldn�t dare to take a plug out of the inside as I only had a 100mm spigot and I am sure my kelton or woodcut bowl saver would have had a dig in causing the piece to run out of true and as I intended a thin wall thickness this would have been disastrous

In the end its 5mm thick thicker than I wanted it but the turning wore me down the noise of my kelton hollowers and the Hunter tools meant I had to were air muffs

Also a good pair of pig skin gloves I cut the fingers off as the chips were as sharp as.

Full face shield with another pair of safety glasses were worn as the chips somehow were getting into my eyes

The shape was a hard one to get right especially the kick out in an easy graceful curve but I think I have ticked all the boxes

At this stage it has just had one coat of Danish oil and buffed ,Tommorow night I will spray with lacquer then Sat morning it has to be delivered to the Royal Easter show

One of my entries in the plain bowl section as usual a rush

Also due to the fact that the entry form had to be in six weeks ago I have under priced big time this as usual ( you know I am sure how it is name ,wood type and price oh know what do I make )

items have to be for sale as part of the rules This is one time I hope my work doesn�t sell

Comments welcome

Oops sorry 10 inches Dia and it sits on a round bottom gracefully rocking when touched

Re: Rocky Bowl 7

#2

Re: Rocky Bowl 7

Dave Moore

My my, that's beautiful work, just beatuiful.

The V grooves are in exactly the right spot too, and a real nice touch.

Someone will buy that, sure as eggs. Hell, I would if I you weren't so damn far away. ;)

Re: Rocky Bowl 7

#3

Re: Rocky Bowl 7

Tery Scott

I could always put some wings on it Dave

Thanks for taking the time to comment

Cheers

Re: Rocky Bowl 7

#4

Re: Rocky Bowl 7

Don at Central Illinois

I don't care how hard it was (since I wasn't turning it) but it is a beautiful piece. Congratulations on taking the beating in turning it.

Re: Rocky Bowl 7

#5

Re: Rocky Bowl 7

Matt Overton

Terry,

Your work has been so unique and awe inspiring that when you turn relatively simple piece like this, you awe us even more with your shear talent! This is an elegant piece to be very proud of.