Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Club equipment question

Posts

Club equipment question

#1

Club equipment question

Chuck Engstrom

Hi folks -- our local turners club, Chesapeake Woodturners, has now accumulated enough equipment for offsite demos that we are talking about getting a small trailer for storing it and moving it around. Our equipment manager has begun to find it cumbersome to load and unload all this stuff in and out of his van, and to store it in his shop between events.

Do any of you belong to clubs that have gotten a trailer to deal with this issue -- or found some other solution for it? We hesitate to invest in a trailer for which we'll have to find storage, tow vehicles, etc as time goes by and personnel change.

We'd be grateful for your thoughts and suggestions.

Chuck Engstrom

Chesapeake Woodturners

Re: Club equipment question

#2

Re: Club equipment question

Fred Holder

Hello Chuck,

I belong to two clubs: The Northwest Washington Woodturners and the Seattle Woodturners. Both clubs have trailers to house their equipment and to move it to the site for the demonstration. So far they have always managed to find someone who will allow the trailer to set in their yard and to haul it to the meetings. Each club has a trailer that it weather proof so that the equipment can be stored in the trailer all of the time it is not in use. I wasn't involved in the selection of the trailers, so don't have any specifics on them.

If you wish, contact me and I'll try to put you in touch with someone who knows something about the model of trailer, etc.

Re: Club equipment question

#3

Re: Club equipment question

Jeff Brockett

The Tennessee Association of Woodturners purchased a nice used trailer several years ago. This trailer has swing open doors and we built a ramp to move the big One Way lathe off and onto the trailer. The trailer is large enough that we built cabinets on one side to store all the tools and accessories that go with the lathe, a compressor, grinder etc. Tie downs were added to the walls of the trailer to secure the lathe for travel. We are fortunate that we are allowed to store the trailer on someone's property. This trailer has lights and brakes - something I would suggest if you are considering the investment. Hope this helps.

Re: Club equipment question

#4

Re: Club equipment question

Skip Beardsley

Don't want to hijack the thread but have a question for those with trailers. Glacier Woodturners Club is looking into getting a trailer. Question is how to control the inside to prevent rust during the winter? Any suggestions?

Skip