Red Gum burl
Tery Scott
This is bigger than the photo portrays 280mm dia
Red Gum Burl
I tried cutting this with my bowl gouges but it was so hard chips were coming off the feather grind I use
I had to revert to my kelton Hollowers and scrape from start to finish
I should have mounted the burl on my grinder and turned the stone I think it would have been softer ,Chips came off like bullets
And I have to sand with oil as the dust was blood read and went every were
The oil did bring out the pleasing grain
finished with lacquer,I dont normally like a gloss finish but I think this goes well
comments welcomed
smooth inside as out



