Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Maple Platter Blanks

Posts

Maple Platter Blanks

#1

Maple Platter Blanks

Bernie Weishapl

I have a chance to pick up a bunch of maple platter blanks. Most of them are 12" wide X 1 1/2" to 2" thick. Here is the problem. Most of them have some sort of spalting. Is this a issue if using as utility plates? Thanks.

Re: Maple Platter Blanks

#2

Steve Kubien

Re: Maple Platter Blanks

Steve Kubien

Any fungus or mold which caused the spalting will be long dead by the time you turn, sand and finish them. What's for dinner?

Re: Maple Platter Blanks

#3

Re: Maple Platter Blanks

John Veerkamp, Western Mo

I'm sure it's a problem. They may be toxic. For no charge I'll take them off your hands and relieve you of the anxiety of these being used by an unsuspecting consumer. I however am imune to this worry having been innoculated by years of turning spalted wood.

Re: Maple Platter Blanks

#4

Re: Maple Platter Blanks

Jorge Casta�eda

Bernie,

As long as they are not punky they will be OK. If still suspicious, I use first sanding sealer and then lacquer. Normally for things that will touch food, all I use is walnut oil, but with spalted wood or any wood too porous, I go the lacquer route, apply several coats and let them dry at least a day between coats and forget it for a while, then a couple weeks later, rub it wit 0000 steel wool.

Re: Maple Platter Blanks

#5

Re: Maple Platter Blanks

Bernie Weishapl

Thanks for the replies. I appreciate it. Sounds like I had better get them but will check to make sure the wood is solid. I tried a cheese platter out of some wood that was kind of soft and slightly punky. It did not work well.