Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Help Repairing a "Funnel"

Posts

Help Repairing a "Funnel"

#1

Help Repairing a "Funnel"

Tom Minehan

I just turned another "funnel" from what would hsve been a bowl with nice grain. I've turned numerous funnels but not tried to save any. I want to try and save this one and need some help. A couple of possible methods come to mind.

1)Turn a "flat" around the hole on the bowl bottom, glue a piece of contrasting wood to it and continue turning.

2) Turn the hole in the bowl bottom round, turn a plug to fit, glue it in and continue turning.

Will either of these methods work (asssuming I don't make another funnel)? I welcome any other ideas and warnings of "gotchas" while trying repairs.

Re: Help Repairing a "Funnel"

#2

You've joined the club !

Don Orr

Both of your ideas are valid repair techniques. Give them a try-what do you have to lose ? Just remember to check your thickness at the bottom a little more carefully. ;) :D

Re: Help Repairing a "Funnel"

#3

Re: Help Repairing a "Funnel"

Bernie Weishapl

I have used your #1 method with good success. I don't do it often but if I have a bowl with some outstanding character I will.

Re: Help Repairing a "Funnel"

#4

Re: Help Repairing a "Funnel"

Wally Dickerman in Arizona

Solution 2, except go to a hardware store and buy a rubber sink stopper to fit. Explain to your admiring public that that's what you intended to do from the beginning..:-))

Hey, I did this once and it went over big at the club Show and Tell....

Wally

Re: Help Repairing a "Funnel"

#5

Don't repair it, finish the funnel

Jorge Casta�eda

Tom,

Turn the spigot (part b) and attach it to part a...

You will be pleasantly surprised and they are great conversation pieces.

Re: Help Repairing a "Funnel"

#6

Dick Hines

Re: Don't repair it, finish the funnel

Dick Hines

One of my funnels I did I put on the end of my dust collector hose. It makes a great , and cheap, dust chute.

Re: Help Repairing a "Funnel"

#7

Re: Help Repairing a "Funnel"

Lan Brady

Tom,

Not the answer you were asking for.

I turned a beautiful maple burl bowl and then cut a hole in the bottom. I actually widened the hole and put pegs around the rim. It sold as a cheese strainer (classic Treenware). The price was higher than I was planning to charge for the bowl.

Good luck with whatever you do, Lan

Re: Help Repairing a "Funnel"

#8

Re: Get a Tompkins Gageit

Steve Criscenzo

I used to turn funnels. Got smart and bought a Tomkins Gageit. Have not made a funnel since.

Steve

Re: Help Repairing a "Funnel"

#9

Keith Tompkins

Re: Get a Tompkins Gageit

Keith Tompkins

Good answer Steve...good answer! :)

Re: Help Repairing a "Funnel"

#10

Re: Get a Tompkins Gageit

Carol Reed

Link?

Re: Help Repairing a "Funnel"

#11

Re: Get a Tompkins Gageit

Jorge Casta�eda

Packard Woodworks among other sell it, or ping Keith directly...