Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

need suggestion for heavy base inlay

Posts

need suggestion for heavy base inlay

#1

need suggestion for heavy base inlay

ILYA Z

I just turned a vase whose center of mass is fairly high up. Also, it's got a fairly small base. To make the vase stable, I want to make a heavy inlay in the bottom. This inlay should be (i) round, (ii) between 1.75 and 2.5" in diameter and between 1/4 and 1/2" thick, (iii) heavy and (iv) made of material that can be glued to the wood. I went to a local tile shop looking for round tile of that size. Did not find anything feasible. The closes I got was a hexagonal piece 2" in diameter. Can you recommend something better?

Thanks!

Re: need suggestion for heavy base inlay

#2

MDF Insert

A. Kapocius

Suppose you turn an MDF insert, then drill tiny holes for buckshot. Unless you have a shotgun.

Al Kapocius

Re: need suggestion for heavy base inlay

#3

Re: need suggestion for heavy base inlay

Dave Staeheli

If you can find a source of brass plate, that might work. Brass will turn on a wood lathe. Kind of a can of worms, but you could also turn soapstone or other soft stone.

Another trick might be to get a round steel disk. I used to go to a local steel/fabrication shop and buy steel disks right off the scrap shelf (for home made faceplates). Then turn a stepped mortice in the bottom of your vase. Glue the steel disk/weight in the bottom mortice. Turn a disk of matching/contrasting wood to fit in the top mortice. Finish as you will.

Re: need suggestion for heavy base inlay

#4

Re: need suggestion for heavy base inlay

John Lucas

I've done both of the above and they work. I've also poured molten lead into a groove. then turned it down flush. It shrinks as it cools so after it cools I pour in some epoxy to keep it from shifting. When it all dries I turn it. Obviously if you have to sand it take precautions, you don't want to breath that dust.

The lead shot imbedded in epoxy works very well and you don't have to melt the lead and worry about fumes.

If it doesn't have to be very heavy use BB's.

Re: need suggestion for heavy base inlay

#5

Re: need suggestion for heavy base inlay

Barry Irby

How about a coil of solder epoxied into the base? Maybe even two layers with a piece of wood over it or a layer of felt or other fabric.

Re: need suggestion for heavy base inlay

#6

Get Thee To A Bait & Tackle Shop

charlie belden

Anyplace that sells fishing equiptment will have lead weights and you should be able to find a 2 or 3" diameteer by 1/2" or thicker disc weight. They're easy to turn, the shavings don't cut quite as much as other metal shavings and there's no fire and hot metal to deal with. And clean shear cuts leave a bright shiny surface which if coated with clear lacquer will stay shiny. It will dull to gray if you don't coat it if you want it less conspicuous.

Re: need suggestion for heavy base inlay

#7

Dick Hines

Re: MDF Insert

Dick Hines

I turned a bowl a couple of years ago that had a small foot. The bowl looked really good. The only problem was it would not stand up. I turned a foot out of blackwood. driled a hole and added fender washers. Then glued the blackwood foot on the bowl and trued it up.

I would suggest glueing the washers in so they don't move around.